Removal and Restoration of electric signalling installations to their nominal state :
- Electronic pedals, model 75
- Electronic pedals, model 82
- Paulvé electromechanical detector
- Silec Cautor electromechanical detector
- Silec Forfex electromechanical detector
- Analog KVB balise
- Digital KVB balise
- SILEC Balise
- Traction Return Connections
- Track Circuit Connections (TC) UM71 and UM71 CB
- Track Circuit Connections ITE
- Jointless TC connections 8700Hz, Jeumont-Schneider or Alstom
- Condensators UM71 CB
- Permanent or worksite (crocodile) fixed signal contacts
- Electric point machines
- Paulvé point detector/li>
- Electric point heating resistances and VCC (Clamp Lock)
Temporary cancellation :
- Detonators
- Permanent signals
- Temporary signals
Technical measures :
S6B technical measures are designed to control a situation which will become unstable due to works. We apply these measures to stabilise the situation and allow the FS SIGNALING operator to restore the installations to normal operations or to restrict the impact of the works on installation operation.
Inspections :
The complementarity between technical inspections and tests is key to achieving the safety levels required for the operation of signaling systems.
Operating tests are designed to check that a system is operating normally under normal conditions of use.
The FS SIGNALING operator carries out the tests on the Electric Signaling Systems, in strict compliance with procedures, to make sure that the installation fully performs its safety function.
The checks set out to ensure installation compliance with document specifications and to verify the ability of the installation to perform its safety function.
The FS SIGNALING operator checks the identity and settings of the components, wiring compliance (wire to wire, connections) of the circuits in operating conditions (conditions, 2-pole isolation, etc.).
Tests :
The complementarity between technical inspections and tests is key to achieving the safety levels required for the operation of signaling systems.
Operating tests are designed to check that a system is operating normally under normal conditions of use.
The HMT-certified FS SIGNALING operator carries out the tests on the Electric Signaling Systems, in strict compliance with procedures, to make sure that the installation fully performs its safety function.
